Baron Lighting & License_BULLET MARKER LIGHTS, SMOOT Manuel d'utilisateur télécharger pdf

Page: 1BA-3400-00

Bullet Marker Light Set Installation

Read this before installing these products! USE FOR TURN-SIGNAL

LIGHTS ONLY DO NOT USE AS RUNNING LIGHTS. OVERHEATING

WILL OCCUR AND THE PLASTIC LENS WILL MELT. WE

RECOMMEND INSTALLATION OF THIS KIT BE PERFORMED BY A

QUALIFIED MOTORCYCLE TECHNICIAN.

Revision: 1.2 - 04/12/2012

Install Time: 40 Minutes

INCLUDED IN THE KIT:

(2) Bullet Marker Lights with Orange Lenses

(2) Optional Red Lenses

(2) 3/8-16 x 1-1/4" Bolts

(2) 3/8-16 x 5/8" Bolts

(2) 3/8" Washers

(2) Rubber Washers

TOOLS REQUIRED:

3/8" drill bit

INSTRUCTIONS:

1. Remove rear wheel and rear turn-signal assembly per factory shop manual procedures.

2. Remove stock 6mm fender mounting screw (you may choose to place the Bullet Lights in either the front or

rear fender mounting hole location). Locate and unplug turn signal power leads from their connectors.

3. The mounting hole must be enlarged using a 3/8" drill bit.

4. Guide wire from Bullet Light through mounting hole and then through supplied washer and 3/8-16 x 1-1/4"

bolt. Align Bullet Light to desired angle and tighten bolt.

5. Plug male bullet connector from Bullet Light into female connector from stock turn signal power lead.

NOTE: A proper ground must be provided for the Bullet Lights. On most models, you must either ground the

fender or one of the Bullet Lights. If the optional red lens is desired, remove set-screw holding amber lens in

position and replace with red lens.

Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or

fitment may be required. Barons bears no responsibility on installation costs associated with this product.

5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]

Page: 1BA-3400-00Bullet Marker Light Set InstallationRead this before installing these products! USE FOR TURN-SIGNALLIGHTS ONLY DO NOT USE AS RUNNING

Pas de commentaire

Baron Lighting & License_BULLET MARKER LIGHTS, SMOOT Manuel d'utilisateur