Baron Chrome Shop_REAR LICENSE MOUNT w_LED LICENSE FRAME Manuel d'utilisateur télécharger pdf

Page: 1BA-3150WR

Warrior License Holder w/ LED Frame

2002-up Yamaha Warrior

Our install guides provide a basic outline on the proper installation of our

products. Further tuning and/or fitment may be required. Baron bears no

responsibility on installation costs associated with this product.

Revision: 1.5 - 09/28/2010

INCLUDED IN THE KIT:

1-License Holder (black)

1- LED Plate Frame (Chrome)

4-M5 stainless hex head screws

2-M6x10 stainless flathead screws

2-M6 nyloc nuts

2-M6 stainless fender washers

4-M5 stainless flat washers

TOOLS REQUIRED:

M4 Allen Wrench

M5 Allen Wrench

Flathead Screwdriver

Phillips Screwdriver

M8 Socket or Wrench

M10 Socket or Wrench

INSTRUCTIONS:

This product is not intended for use with stock turn signal assemblies. If using marker lights or other

aftermarket turn signals, install according to instructions supplied by manufacturer. Bolt to tabs provided and

plug into wire harness where stock lamps were disconnected. If you do not plan on using tabs for marker lamps

they may be trimmed off before installation.

1. Remove rear fender from bike.

2. Remove plastic license holder/sub fender from fender.

3. Remove tail lamp from plastic license holder/sub fender. You will need to trim off the molded-in plastic

post from rear of stock tail lamp to facilitate flush mounting of light to Baron bracket.

4. Install tail lamp onto new Baron License Holder using stock sheet metal screws

5. Install license plate into new license holder using the chrome frame and the M5 hex screws and washers.

(Note: some state plates may require trimming). LED frame wiring should run under the plate. Plate

screws need to be snug, but not too tight as to crush the plate wiring.

6. Place tail lamp bezel around tail lamp.

7. Install new license holder into fender and secure with two washers and nuts on existing studs on top, and

two flathead screws in existing nuts on each side. Tighten securely.

8. Splice LED Plate frame wires into stock wiring harness

9. Plug in tail lamp.

10. Check for proper operation of tail and brake lamps, and turn signals if used.

Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or

fitment may be required. Barons bears no responsibility on installation costs associated with this product.

5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]

Résumé du contenu

Page 1 - 2002-up Yamaha Warrior

Page: 1BA-3150WRWarrior License Holder w/ LED Frame2002-up Yamaha WarriorOur install guides provide a basic outline on the proper installation of ourp

Commentaires sur ces manuels

Pas de commentaire

Baron Chrome Shop_REAR LICENSE MOUNT w_LED LICENSE FRAME Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour les motocyclettes Baron Chrome Shop_REAR LICENSE MOUNT w_LED LICENSE FRAME. Baron Chrome Shop_REAR LICENSE MOUNT w_LED LICENSE FRAME User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour les motocyclettes Baron Chrome Shop_REAR LICENSE MOUNT w_LED LICENSE FRAME