Baron Grips & Risers_RISER MOUNTING KIT - Yamaha_Som Manuel d'utilisateur télécharger pdf

Page: 1BA-7410-20

RISER MOUNTING KIT - Yamaha & Suzuki Models

CAUTION! We Strongly recommend that a qualified technician install this kit

if you do not completely understand the instructions prior to the install.

Revision: 1.8 - 04/12/2012

Install Time: 60 Minutes

INCLUDED IN THE KIT:

(2) 1/2" to 14mm Studs

(2) 12mm Washers

(2) 12mm Nylock Nuts

(2) 12mm Hex Nuts

INSTRUCTIONS:

1. Apply RED Loctite® on the 1/2" section of the supplied studs (this is the one with the course thread).

2. Thread the stud into the bottom of the riser as tight as you can with your fingers. There is no need to use

pliers or Vice Grips here!

3. Repeat this procedure on the remaining riser.

4. Slide the riser into the triple tree, and secure with a supplied washer and nylock nut.

Note: We strongly recommend the application of Loctite®, or a similar material, on the threads of all bolts.

Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or

fitment may be required. Barons bears no responsibility on installation costs associated with this product.

5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]

Page: 1BA-7410-20RISER MOUNTING KIT - Yamaha & Suzuki ModelsCAUTION! We Strongly recommend that a qualified technician install this kitif you do n

Pas de commentaire

Baron Grips & Risers_RISER MOUNTING KIT - Yamaha_Som Manuel d'utilisateur