Baron Tools_Oil Drain Tool - Billet Aluminum - For 09+ T Manuel d'utilisateur télécharger pdf

DRAG SPECIALTIES

OIL DRAIN ADAPTER

P/N 0712-0314

INSTALLATION INSTRUCTIONS

NEW 12/2010 Page 1 of 1

3501 Kennedy Rd, PO Box 5222, Janesville, WI 53547-5222

P/N 0712-0314

ATTENTION INSTALLER (if other than owner):

Please forward this Instruction Sheet to the purchaser

of this product. These instructions contain valuable

information necessary to the end user.

INTRODUCTION: These instructions describe the

procedure for properly installing and using the Oil Drain

Adapter on the 2009-2011 Touring models.

Review instructions carefully before beginning, as they

contain important information. Please retain for

future reference.

Particularly important information is distinguished in these

instructions by the following notations.

NOTE: A NOTE provides key information to make

procedures easier or clearer.

CAUTION: A CAUTION Indicates special procedures that

must be followed to avoid injury to a motorcycle operator

or person inspecting or repairing the motorcycle.

WARNING!: A WARNING indicates special procedures

that must be followed to avoid injury to a motorcycle

operator or person inspecting or repairing the motorcycle.

NOTE: This tool allows you to drain the oil out of the oil tank

without the oil running all over the cross-over plate on the

bottom of the frame.

PROCEDURE:

1. Place the motorcycle in a secure upright position. We

suggest using a lift on the frame that allows the engine oil

drain plug to be exposed.

2. Using the 5/8” socket

and ratchet, loosen the

drain plug on the bottom

of the oil pan.

3. Insert the adapter

through the hole in the

crossover plate and

locate it over the

drain plug.

4. Rotate the adapter

counter-clockwise (to the

left) to engage the lug on

the side of the adapter

with the lip on the cutout

in the crossover plate.

5. Conﬁrm that you have an

even seal around the top

of the adapter and the

oil pan.

6. Remove the drain plug

with the ¼” hex bit and

ratchet with extension.

7. Allow the oil to drain

through the center of

the adapter and into the

drain pan.

8. Allow all oil to drain out of the oil pan.

9. Re-insert the drain plug and tighten ﬁnger tight.

10. Remove the oil drain adapter.

11. Tighten the drain plug to 14-21 ft-lbs.

12. Install the proper amount of oil in the oil tank.

WARNING!: Before operating motorcycle, be sure all hardware

is tight.

INSTALLATION INSTRUCTIONS 1

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

DRAG SPECIALTIES OIL DRAIN ADAPTERP/N 0712-0314INSTALLATION INSTRUCTIONSNEW 12/2010 Page 1 of 13501 Kennedy Rd, PO Box 5222, Janesville, WI 53547-5222

Commentaires sur ces manuels

Pas de commentaire

Baron Tools_Oil Drain Tool - Billet Aluminum - For 09+ T Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour les motocyclettes Baron Tools_Oil Drain Tool - Billet Aluminum - For 09+ T. Baron Tools_Oil Drain Tool - Billet Aluminum - For 09+ Touring Models User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour les motocyclettes Baron Tools_Oil Drain Tool - Billet Aluminum - For 09+ T